• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
  • The Winners of the three Retevis radios 16 Anniversary giveaway are announced!! Click Here to find out if you won!

ok guys finished my wilson 5000 vs radio shack antenna test

I would suspect the wilson would outperform the rat shack antenna by a small margin. Given that their whips are the same length, The tightly wound coil on the ratshack is acting more like a wire wound resistor than the wilsons substantially wider coil. If tested in a controlled enviroment I bet the wilson would show a higher Q (more efficient)

But Real world tests kinda say it all...........Im surprised by the find...Good Work
 
  • Like
Reactions: Tallman
Long skinny coils are less efficient than short fat ones, but the difference is very small. I won't guess how those two antennas compare, but I have to think there won't be a significant difference between then.
- 'Doc
 
I've made some home brew base antennas with 4' Firestiks that performed pretty good. Does anyone have an idea how a couple of R.S. base-loaded antennas would work compared to the top-loaded fiberglass Firestiks in a horizontal or inverted v configuration?
 
The tightly wound coil on the ratshack is acting more like a wire wound resistor than the wilsons substantially wider coil. If tested in a controlled enviroment I bet the wilson would show a higher Q

The higher "Q" will also enhance the tuning over a broader range of frequencies.
 
The higher "Q" will also enhance the tuning over a broader range of frequencies.

An antenna that has just enough bandwidth to cover the CB band (0.45 MHz) will have a Q of about 62, while an antenna with the same center frequency with 1 MHz bandwidth will have a Q of about 27.

Wider bandwidth means lower Q, not higher.

Q = fc / (f2 - f1)

Where:

fc = center frequency
f1 = lowest frequency in the range
f2 = highest frequency in the range


The DB
 
  • Like
Reactions: Captain Kilowatt
An antenna that has just enough bandwidth to cover the CB band (0.45 MHz) will have a Q of about 62, while an antenna with the same center frequency with 1 MHz bandwidth will have a Q of about 27.

Wider bandwidth means lower Q, not higher.

Q = fc / (f2 - f1)

Where:

fc = center frequency
f1 = lowest frequency in the range
f2 = highest frequency in the range


The DB


You beat me too it. (y) Low Q=wide bandwidth while high Q=narrow bandwidth but with greater efficiency usually.
 

dxChat
Help Users
  • No one is chatting at the moment.