• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

ok guys finished my wilson 5000 vs radio shack antenna test

I would suspect the wilson would outperform the rat shack antenna by a small margin. Given that their whips are the same length, The tightly wound coil on the ratshack is acting more like a wire wound resistor than the wilsons substantially wider coil. If tested in a controlled enviroment I bet the wilson would show a higher Q (more efficient)

But Real world tests kinda say it all...........Im surprised by the find...Good Work
 
  • Like
Reactions: Tallman
Long skinny coils are less efficient than short fat ones, but the difference is very small. I won't guess how those two antennas compare, but I have to think there won't be a significant difference between then.
- 'Doc
 
I've made some home brew base antennas with 4' Firestiks that performed pretty good. Does anyone have an idea how a couple of R.S. base-loaded antennas would work compared to the top-loaded fiberglass Firestiks in a horizontal or inverted v configuration?
 
The tightly wound coil on the ratshack is acting more like a wire wound resistor than the wilsons substantially wider coil. If tested in a controlled enviroment I bet the wilson would show a higher Q

The higher "Q" will also enhance the tuning over a broader range of frequencies.
 
The higher "Q" will also enhance the tuning over a broader range of frequencies.

An antenna that has just enough bandwidth to cover the CB band (0.45 MHz) will have a Q of about 62, while an antenna with the same center frequency with 1 MHz bandwidth will have a Q of about 27.

Wider bandwidth means lower Q, not higher.

Q = fc / (f2 - f1)

Where:

fc = center frequency
f1 = lowest frequency in the range
f2 = highest frequency in the range


The DB
 
  • Like
Reactions: Captain Kilowatt
An antenna that has just enough bandwidth to cover the CB band (0.45 MHz) will have a Q of about 62, while an antenna with the same center frequency with 1 MHz bandwidth will have a Q of about 27.

Wider bandwidth means lower Q, not higher.

Q = fc / (f2 - f1)

Where:

fc = center frequency
f1 = lowest frequency in the range
f2 = highest frequency in the range


The DB


You beat me too it. (y) Low Q=wide bandwidth while high Q=narrow bandwidth but with greater efficiency usually.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.