• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Part needed for Turner Super Sidekick Microphone

Jim1428

Active Member
Feb 13, 2017
99
103
43
76
I am looking for a Motorola chip for this mike, part number is MFC 4000B.

I have found several places on line selling this part or the equivalent for $20.00 or more, is this the going
rate or can it be obtained for less?

Any suggestions would be appreciated.
 
  • Like
Reactions: 357

I am looking for a Motorola chip for this mike, part number is MFC 4000B.

I have found several places on line selling this part or the equivalent for $20.00 or more, is this the going
rate or can it be obtained for less?

Any suggestions would be appreciated.

I'd buy a beater off ebay and swap the chip
 
  • Like
Reactions: RT431 and Woody-202
Try a lm386, that's what the sidekicks i have seen had in,
It might work, the Motorola chip is a 4 pin device, the lm386 is 8 pin, looking at the data sheet the schematic is similar, I will compare both schematics for compatibly.

Thanks for the tip.
 
im guessing turner made 2 versions of the board,
i remember looking in my ssk and thinking they could have used a lower noise lower output opamp rather than something more commonly found driving a speaker in low outout audio devices.
i never did hook a loud speaker up to see if it really would drive it to a reasonable sound level.

good luck
 
im guessing turner made 2 versions of the board,
i remember looking in my ssk and thinking they could have used a lower noise lower output opamp rather than something more commonly found driving a speaker in low outout audio devices.
i never did hook a loud speaker up to see if it really would drive it to a reasonable sound level.

good luck
I am going to try the lm386 just for grins, it may work better than the original, you never know until you try it.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ COWBOYS:
    Denton GL 1000 ham amp comes on, but will not key up
  • @ COWBOYS:
    What can I do to make my Denton GLS 1000 amp to load ?
  • @ AudioShockwav:
    Try starting a new thread in the Amplifier section and asking the question, more people will see it to respond.
  • @ iw7ed:
    hello