Hi.
Had a similar prob, but once programmed its there..
Start:
Press power, PA, and dimmer keep these pressed down and the code button flashes keep your finger on these three buttons until the screen goes blank and then press M1 and then turn the radio off: this will give you the international mode with a coverage of 26.065-28.785Mhz(with alphas) AM, FM, USB, and LSB modes!
When in this mode the dimmer switch acts as a band change .
After programming, then press and hold the mode button to change from AM/FM to USB/LSB modes.
If you dont have the CODE to operate the radio, there is a Factory Default code of 4 short depressions of the PROGRAM key. This should work if the code has NOT been changed.
The MR3 module appears to be a factory update/mod and is in my radio also.
I hope this helps
Roger
</p>
Had a similar prob, but once programmed its there..
Start:
Press power, PA, and dimmer keep these pressed down and the code button flashes keep your finger on these three buttons until the screen goes blank and then press M1 and then turn the radio off: this will give you the international mode with a coverage of 26.065-28.785Mhz(with alphas) AM, FM, USB, and LSB modes!
When in this mode the dimmer switch acts as a band change .
After programming, then press and hold the mode button to change from AM/FM to USB/LSB modes.
If you dont have the CODE to operate the radio, there is a Factory Default code of 4 short depressions of the PROGRAM key. This should work if the code has NOT been changed.
The MR3 module appears to be a factory update/mod and is in my radio also.
I hope this helps
Roger
</p>