Robyn DG-30

[ClaimJumper]

Does anybody have or know where I can get a pic of a robin dg30.? Inside near the power Inlet. This was where the power cables came in .
This is the lower left corner of the rig. The part I'm interested in.
This came out of that lower left corner of the PC board. The coil you see in the board and this one went to positive and negative terminals on the jacked up power Inlet housing. I just want to clean it up and put it back to stock. Might have to just run cables through the chassis. Sure would be nice to see what a stock one looks like.

 

[Shummy]

These may not be the best pictures, but I did modify my DG-30 by adding a Uniden 3pin power Jack a couple years ago.

 

[Shummy]

Looks like your missing a RF choke L20 or L21

 

[ClaimJumper]

Awesome! Thanks!

 

[ClaimJumper]

These may not be the best pictures, but I did modify my DG-30 by adding a Uniden 3pin power Jack a couple years ago.
View attachment 70932View attachment 70933View attachment 70934View attachment 70935View attachment 70936

Thanks for the pics.

 

[ClaimJumper]

These may not be the best pictures, but I did modify my DG-30 by adding a Uniden 3pin power Jack a couple years ago.
View attachment 70932View attachment 70933View attachment 70934View attachment 70935View attachment 70936

Do the speaker wires lead straight to the external speaker Jack on the inside of the chassis? That's where I found them on this one I'm working on now.

 

[ClaimJumper]

Looks like your missing a RF choke L20 or L21View attachment 70937View attachment 70938

I've got both chokes now brand new. I'll be installing those tomorrow and hopefully give this back to the owner.

 

[Shummy]

Do the speaker wires lead straight to the external speaker Jack on the inside of the chassis? That's where I found them on this one I'm working on now.

Thats a 10-4

 

[ClaimJumper]

Thats a 10-4
View attachment 71029

That's why I love this site! Thank you very much sir.

 

[ClaimJumper]

Do the speaker wires lead straight to the external speaker Jack on the inside of the chassis? That's where I found them on this one I'm working on now.

You can see why I asked. This doesn't look like factory work.

 

[ClaimJumper]

Okay the Robyn is up and running.
The only thing I'm going to do to it now is what Shummy did to his with the three pin power plug. I'm assuming that matches straight up to the holes that are already in the chassis?

 

[Shummy]

Okay the Robyn is up and running. The only thing I'm going to do to it now is what Shummy did to his with the three pin power plug. I'm assuming that matches straight up to the holes that are already in the chassis?

I believe you may have to do a little fine tuning with the Dremel tool. Those Uniden 3pin jacks are pretty big compared to the Robyn 2 pin stock jack.

 

[ClaimJumper]

Okay. Well if I can't find the stock Jack, which I doubt I can, that's what I'll do. The stock one that was in there was just a melted blob of plastic.

 

[ClaimJumper]

Well the Robyn is done now. Thanks for your help Shummy! All the schematics and tips along the way. I did the three pin power cable jack. Came out decent, I got it a little crooked though.

 

[ClaimJumper]

I cleaned it up a little bit with a stone in the Dremel . I drilled the other hole for the mounting bolt, and had to slightly cut the insulator on the PA Jack in order to make the three pin fit. Not too difficult though.