-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Sark 100 antenna analyzer test frequency
- Thread starter Jim5570091
- Start date
Thanks. I have this manual, maybe my issue with it wasn't fully understood. Look at the picture attached. The sark is showing the test frequency is 40.810 mhz. Connected to a frequency counter it is actually putting out 27.206 mhz. they should match. Right?
I'll have a measure of mine once I recharge the battery.
Havent used it in awhile.
While Im here havea look on https://sm6why.n.nu/sark-100
Havent used it in awhile.
While Im here havea look on https://sm6why.n.nu/sark-100
Good question. I haven't used mine on a single frequency yet. I'm scanning different bands on the antennas I have. In fact I never actually calibrated mine. I attached a 50 ohm dummy load to see what the SARK100 said the ohms were. Then I measured the dummy load with my multimeter, and they were exactly the same. So I called it good.
I know my antenna system is spot on. When I check it @40.810 it’s 49 ohm but 27.205 is off the chart. I built the cal connectors and calibrated it when I first got it. But never figured out the test frequency discrepancy
How did you build the calibration loads? I would like to do this myself.I know my antenna system is spot on. When I check it @40.810 it’s 49 ohm but 27.205 is off the chart. I built the cal connectors and calibrated it when I first got it. But never figured out the test frequency discrepancy