Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

setting up a bench

M

MNTSIDE

Member
Jan 31, 2021
36
7
18
61
Looking for a little help setting up a test bench for CB and export radio testing .
Need help with the proper way to set up Oscilloscope with an rf sampler (coupler)and also watt meter and freq counter,im assuming these all need some type of coupler in between them.

Planed equipment to be purchased :
Siglent SDS1202XE
LP100a watt meter(I believe comes with a coupler )
Dummy load

Haven't figured out anything for the freq counter yet (any suggestions )

Any help would be great
Thanx
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom