STRYKER SR-955HP very, very, very low power

[Crambone]

I was using my SR-955HP and it just went almost dead. I tested Q25, 45, 46 & 47 and they tested good with a cheap Chinese tester.
Since I had the desoldering I just replaced them all with IRF520’s.
I’m seeing the following voltages on them. Any help would be apreciatted.
Q25. G. D. S
RX. 0. 4.9v 0
TX 0. 4.8v. .4mV

Q47. G. D. S
RX. 0. 4.9V. 0
TX. 3.8V. 4.8V. .4mV

Q45. G. D. S
RX. 0. 0. 0
TX. 4V. -178mV .07mV

Q46. G. D. S
RX. 0. 0. 0
TX. 4V. -178mV. 0

Q49. B. C. E
RX. 0. 0. 0
TX. 1.2V. 8V. .6V

 

[sp5it]

Grab RF probe and search where power disappear.

 

[Crambone]

Grab RF probe and search where power disappear.

Not so adept on following schematic any suggestions on a starting point and path to follow?

 

[sp5it]

On TX, with RF probe measure voltages on input and output of following transistors.
Based on that schematic https://www.worldwidedx.com/cbt/radios/stryker/sr_955hpc/graphics/Schematics.pdf

Q49 B= C=
Q25 G= D=
Q45 G= D=
Q46 G= D=

Mike

 

[Crambone]

On TX, with RF probe measure voltages on input and output of following transistors.
Based on that schematic https://www.worldwidedx.com/cbt/radios/stryker/sr_955hpc/graphics/Schematics.pdf

Q49 B= 248mV C= 2.5V
Q25 G=55mV. D= 24mV
Q45 G= 253mV. D= 63.8mV
Q46 G= 292mV. D= 54mV

Mike

 

[sp5it]

Between C of Q49 (2.5V) and G of Q25 (55mV) power disappear.
Check C237, C238 and D47.
Mike

 

[Crambone]

Between C of Q49 (2.5V) and G of Q25 (55mV) power disappear.
Check C237, C238 and D47.
Mike

Thanks I didn’t forget you I got shipped out for a month