toggle switch board

[1iwilly]

Does anyone here with a 2k that they can take a few clear pictures of the bottom side of the toggle switches board showing where the wires are solder too?
i finally have the time to put mine back to stock the switches were used for extra channels traces were scribe deep gouges and wires cut I've done the best i could with the schematic but everyone knows these schematics don't look clear

 

[jtrouter]

Here is what i have hope this helps!

 

[1iwilly]

Here is what i have hope this helps!

yes i have that but I'm looking for a pic showing the wires

 

[nomadradio]

I know we did this years ago just to have that info on hand when needed. But I still haven't dumped my whole life into the cloud, yet. Can't look for it until I get to work. With any luck it didn't get flushed in the last disk crash. Been a while.

Knock on wood.

73

 

[1iwilly]

I know we did this years ago just to have that info on hand when needed. But I still haven't dumped my whole life into the cloud, yet. Can't look for it until I get to work. With any luck it didn't get flushed in the last disk crash. Been a while.

Knock on wood.

73

thanks bud

 

[nomadradio]

So here's what I found.

Nothing about where any of the wires goes. Just where they're attached and what color are all this reveals.

73

 

[1iwilly]

thanks that's what i needed