I have removed the original 5 pin din plug and thought I had it all figured out to convert to a standard 4 pin Cobra/Uniden...but I'm guessing I have something backwards.
Radio RX fine with no mic hooked up (which it shouldn't) and goes into TX with the mic plugged in and gives me hellova noise when I key the mic. I'm guessing I have the rx, tx & audio bassakwards. I was only using the original mic & plug to go by on wiring and thought I had it zeroed out in my mind & board. Grr! Something simple and I still got it wrong...cb tricks didn't have a schematic...Any ideas!?
I'm at work at the moment so I can't look at the radio to say which pin wired to where on the board...
Radio RX fine with no mic hooked up (which it shouldn't) and goes into TX with the mic plugged in and gives me hellova noise when I key the mic. I'm guessing I have the rx, tx & audio bassakwards. I was only using the original mic & plug to go by on wiring and thought I had it zeroed out in my mind & board. Grr! Something simple and I still got it wrong...cb tricks didn't have a schematic...Any ideas!?
I'm at work at the moment so I can't look at the radio to say which pin wired to where on the board...