Yeah,but it's going in a brand new Ranger TRE-936ffc which is similar to a 959 but instead of a slider switch it has a push button to switch the ANL/NB on. I can get another on/off volume switch and mount that where the mike gain is and use that for mic gain and switched a talkback volume switch. Get another three position S/RF,CAL,SWR switch,change out the talkback volume switch and use that as a band switch. Clip the roger beep leads and solder those together and use the roger beep push button switch for a 10 kc up switch.
Of course,as cheap as Copper is selling these 936's I could buy another and keep it stock.
P.S. I might get one for my 959 but I'll check for cold solder joints on the 959's Viagra board first and put a 10 ohm resistor where I have the R133 bypass jumper soldered in.
Just pondering.