• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

WANTED - Mosley TA-53-M or TA-63-M Beam Antenna

st2k10

Member
Dec 11, 2012
3
0
11
Looking for a good working, reasonably priced Mosley TA-53-M or TA-63-M beam antenna.
Email: va3guy(at)hotmail(dot)com
 

there has been a Mosley on QTH for over a week

Listing #1445788
Nevermind.. its a 57
 
Last edited:
HyGain TH6DXX
Original Lincoln Nebraska manufacture HyGain TH6 antenna. Only up for a short while and subsequently stored indoors. All stainless hardware. Original owner. As new condition. $325, pick up near Syracuse NY.
Listing #1441876 - Submitted on 06/02/19 by Callsign N2MF

Yea long drive from nr Ottawa...but nice price...and yes not MOSLEY
 
  • Like
Reactions: Captain Kilowatt
HyGain TH6DXX
Original Lincoln Nebraska manufacture HyGain TH6 antenna. Only up for a short while and subsequently stored indoors. All stainless hardware. Original owner. As new condition. $325, pick up near Syracuse NY.
Listing #1441876 - Submitted on 06/02/19 by Callsign N2MF

Yea long drive from nr Ottawa...but nice price...and yes not MOSLEY

Nice price on the TH6. I wanted to abandon my Explorer 14 and A3WS in favour of a singke TH11DX but spending too much on travel this year so I hope to install the existing antennas and maybe get the TH11DX in another year or two.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.