Looking to buy a Uniden Grant lt and a Uniden Madison. Would like them to be in great shape. Near minty. Let ne know what you have, please include price and pic if pissibke. Thanks
Would you be interested in a uniden grant xl instead of the LT? I have a uniden grant xl that was refurbished by my tech.
This is what was done to the radio: Clarifier unlocked, 10khz up and down slider 10 turn pot, para dynamics frequency counter, variable power knob on back of radio so you can adjust dead key, turbo echo (dual echo located on the Rf gain knob) , the radio also has new voltage regulators, finals, and power transistors were re-greased as well, 5 pin mic jack has been changed to a 4 pin, the swr-cal control is located inside the radio now and that the swr bridge is fully functional and can be calibrated using the custom control located inside the radio towards the front, talkback on/off on cb/pa switch, extra channels located in hi/low & brt/dim switches, white s-meter led, upgraded the lead to 20 gauge pure copper from the coax connector to the board, peaked, tune and full alignment on rx and tx, and swing kit installed..
Thanks Troubleshooter for the reply. Sounds like a nice radio you have there. I already have a couple of the grant xl radio's. I am really looking for a lt. I appreciate the offer.
Would you be interested in a uniden grant xl instead of the LT? I have a uniden grant xl that was refurbished by my tech.
This is what was done to the radio: Clarifier unlocked, 10khz up and down slider 10 turn pot, para dynamics frequency counter, variable power knob on back of radio so you can adjust dead key, turbo echo (dual echo located on the Rf gain knob) , the radio also has new voltage regulators, finals, and power transistors were re-greased as well, 5 pin mic jack has been changed to a 4 pin, the swr-cal control is located inside the radio now and that the swr bridge is fully functional and can be calibrated using the custom control located inside the radio towards the front, talkback on/off on cb/pa switch, extra channels located in hi/low & brt/dim switches, white s-meter led, upgraded the lead to 20 gauge pure copper from the coax connector to the board, peaked, tune and full alignment on rx and tx, and swing kit installed..