Recent content by 1iwilly

Have this JCPenney 6247 in good condition, no mods, looking for trades or an offer, have no use or need for it

Thanks for the input

I am working on a static 575-M6 with the green board. When I move the tone slider to 0, I don't notice any hint of bass. However, as soon as I start moving the slider up, I notice that the treble becomes stronger. I changed the two 4.7 µF electrolytic capacitors, thinking that they might be...

Looking for input if adding this with my Heil PR-781 mic would make up for the low audio from my Icom 746 non-pro Klark Teknik Mic Booster CM-1 In-Line Microphone Preamplifier BH# KLMICBSTRCM1 • MFR #0838AAT86001 CAMVATE 48V Phantom Power Supply with USB Cable Adapter and...

For sale or trade: Icom 746 non-pro with Mars mod

Not paying attention, I meant to post it in the ham section

Selling my Heil PR-781 mic with shock cage and cable wired for Icom with voltage cap inside, asking $180.00 plus shipping from FL

i have a working one for $125.00 plus shipping, black face. I'm keeping the white face one. i the only electrical plug i have for it connects to my power supply not a wall adapter

Today, I dropped off my two ICOM radios, the 7300 and the 746, to recalibrate the S meter and to fine-tune the receive and power meters. I asked the technician if he could check the ALC on the 7300. He responded that nobody uses ALC anymore. Did I miss something over the last five years, or is...

Time to experiment again using a Myantenna 40-10 56.1 and a 1.1 current choke. The only bands of interest are 40, 20, and 15 meters. The antenna will be used in an inverted V with the apex 30 ft above ground. I'm trying to find out what size coax jumper to use as the counterpoise between the...

element is sold

Looking for a recommendation for a high-power attenuator pad of 2.5dB for my Icom 7300 for the ALC overshoot i tried this old skool gadget, but it's no go. The variable is very sensitive . And the overshoot is still there . This is the one i just tried today:

i found another 575-m6 i another box, so 4 Astatic mic 3=575-m6 and 1 amplified tug-8 still for $200.00 plus shipping. I'm done with CB stuff

i have a working Astatic 575-m6 and a 2nd one for parts or to fix it also works, but needs a better housing and the cable. Also, an amplified D104 tug-8 is in good working order. Both are wired for a 4-pin Cobra. asking $200.00 for all, plus the ride from Florida working towards that new ICOM...