You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
As far as I know the cb band 148f was made for Cobra by Ranger.
I've sold a couple 360's to guys who put a 148 dx faceplate on them. Same radio, built in the same factory.
I have 3 Grant's, one has a 10khz mod the other 2 are stock, all 3 recently tuned and aligned by Kelly Poots in Las Vegas. One has the rf mic gain a teeny bit bent, but still functional. $200 shipped each, $175 for the one with the bent know.
Pretty much stock (no mods I'm aware of apart from the resistor diode for the mic) Malaysia made 148, shows some wear but not terrible. Meter works, has white LED, no segments out. K40 speech processor mic. $175 shipped priority mail.
Tx is good, signal appears to be good, the audio out of the speaker is low. Rf gain all the way up, volume all the way up, it's just not very loud. All modes, tried different speakers, both in the mobile and in the house. Any ideas?
As soon as you push the scan button it instantly goes to 26.000 and stays there, can't change frequency with the buttons or channel knob, it won't scan up or down, you have to push the manual button to go back to normal operation.
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.