Recent content by auspot

I sent you an email but no answer have a question about the car collector have a few more parts, steering wheels, brake pedal or shifter? steering coloum is in fairly good shape also parts of the karosene lamps etc auspot auspot4@hughes.net

the correct answer The correct answer to my question is a simple 2 letter word NO! auspot

Really??? Like I said before there are many people trying to sell what they think is a rife machine this is an example (Rife Machine Operator Sued) Dr Rife did not do foot massage as far as I know. This is for my own personal use and all I asked for was some information. Also you have...

The glass tube in about 1 inch in diameter 20 inches long has a big bubble in the middle. There are metal pieces in each end of the tube. Wires attach to the ends of the tube and it will glow when you send a freq to it. It works, the system works and you need to read about Dr Rife to find...

hubs My antenna came with 2 plastic hubs they must of run out of the metal ones. auspot

zapper??? If you check out Ms Clarks zapper you will find out it is not very useful as you can only get one freq unless you change the resistor etc. One of the schematics was faulty as you could not get any output! also it is a very weak signal! :thumbdown: With Ms Clarks zapper you zap...

hubcaps I have a set of 4 wire spoke hubcaps 15 inch used cost $80 new about 25 years ago will sell ya u pay freight also have a helicrafter (sp) receiver from the 50's still works probably has about 4 lbs of dust on it how about some clutch plates for a model "T" ford or a old beat up...

The only thing I need to know is will the zeners work and how big or what capacity is needed. Abdominal_inflammation - 2720, 2489, 2170, 2000, 1865, 1800, the 2720 is 2 thousand 7 hundred and twenty or 2.72K or .00272 mhz, some people might think it is 2,720Khz or 2/720 mhz as this has to be...

Captain Kilowatt Did you read my last post? Do you understand what I am trying to do? I was hoping the zeners would stop the feed back to give me time to get the swr down under 2 auspot

SWR problem Its for medical use. You don't transmitt to someone. You use a signal general to produce a square wave freq which goes threw a cb radio to a linear to a antenna tuner to a balum to the sealed tube which emits radio waves. check this out perhaps you will understand what I am...

the project that I'm building uses a glass tube running a cb radio with a linear. I have a very hard time trying to get the swr down to 1.1 or even under 2. If an antenna would work I would have no problem. My question is can I put zener diodes after the antenna tuner to keep from...

hubs the hubs are for a PDL 2 mine came with 2 plastic ones trying to fix it to work 10 meters auspot

I make my own I use the transformer 15/30 volt converts ac to dc cut the ends off and split the wires and put a gator clip on each wire need a clear glass bowl that will hold a little more than a quart distilled water 2 pieces of 12 gauge pure silver wire .9999 pure roll up one end like a...

Would anyone have the metal hubs that hold the rods on the ends. I need two of them. The plastic ones that I have broke. Thanks for any help auspot