You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Working on a connex cx3300 hp with no tx. Was thinking something was wrong with the pll section of the board but its receiving fine. Have no transmit on AM or FM.
I have another radio sitting on the bench on and when I key the mic on the connex I'm getting a signal on the other radio but no...
I just picked up a Cobra 29 ltd chrome that's not working. Radio is as dead as a door nail. Doesn't power on or anything. Looked for cold solder joints and anything burnt up but it all looks good. Any ideas of what else to check?
Just picked up two connex cx3300s. One is newer and the other one is an older readio. The newer one has no modulation on AM but works fine on FM. The older one works fine on both AM and FM but has low modulation. R228 has been cut in both radios so I would assume they should both have plenty of...
Ive got a Northstar NS-9000 I'm working on now. Radio is pretty much dead. Other than a little bit of noise from the speaker is does nothing. None of the lights light up or anything on it. Would a bad voltage regulator cause that or am I looking in the wrong spot?
Does it after the radios has been on. Ive had radios do this where the pll side of the board had a bad connection but this one the transmit led is not turning red during transmit when the problem occurs. I seem to recall that being related to something else but I cant remember what now.
I have a General Lee here Im tinkering with. The radio is loosing receive and transmit. When you key the mic the RX/TX led will not change color. Its not a mic problem as Ive tried several different mics and it still does the same thing. Any help would be appreciated!
I have a cobra 29 ltd classic I'm working on here. The radio appears to have been hooked up backwards at some point. I had to replace the reverse polarity diode and re solder a burnt trace on the board.
The radio powers up now but the receive isn't acting right. When receiving any station the...
Changed the PLL chip. Turned on the radio and it seemed fine. Had other things to do so I shut it off and disconnected it. Come back to finish it up and tried it again and its still all over frequency. Checked the frequency at the one pin on the pll chip and its showing 10.24? There has got to...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.