Recent content by Copycat32

I have the same radio set it up for gmrs nuts pmr a couple other frequencys.. As far as gmrs murs I ordered an gm Rs/murs from Ed fong working great Ed's very helpful if you have questions or problem hell help you over the phone.. The ibly thing you will need is a 10 foot length of...

Thank you.. Very much appreciated

Hi all I'm recapping a cobra 89gtl and would like to do an alignment I know it's different from the 89xlr dos anyone have the information on this? Thank You

Hi all just purchased a president Richard 10 meter radio did the 11 meter mod went into service menu and tried to up the mosulation but can't get much more then 3 to 40 % regardless of the power or audio settings or mic being used.. Any help would be greatly appreciated Thank You

Hi all I picked nup a president Bill 2 fcc at an estate sale.... it smoked when I started to transmit had output at first the 2 4.7 ohm resistors neer the power input got smoking hot litterly then nothing replacesd the final transistor still no output have receive.. Don't...

Hi no not yet I have the antena the radio took everything down to upgrade and had an operation so I'm down till spring just got hit wit a foot of snow and 0 temps updating cb hame gmrs fm stereo antennas and cables hope to be back on the air b4 summer

Hi OK Soni did the diode mod helped greatly with the audio ran a solder bridge a gross where the jumper would be and got good swing .. B4 bridging was dead keying 3.5 even maxing in the firmware after the bridge now peaking 18 to 20 with 100% clean strong audio looks great non...

Just saw this diode mod will this work on the early ver of Bill 2.. No jumpers or while to cut on this board

Just acquired a president Bill 2 fcc opened up the case no white wire no jumpers all I was able. To do was bring the power up ro 3.8 watts and increase the audio slightly to about 60 % with stock or power mic does anyone know if there a limiter mod for this version? I...

I'm disabled non a very tight budget the 779uv works for. Me I figured outbthe frequency setting and see I can do a final upgrade to get 40 to 45 watts out.. But building my own base antenna.. Should be close. To. 9 db gain.. Working a a mobile antenna design.. Thank You all for...

Thank you I set the frequency range after power of and on got all my GMRS/FRS REPEATERS MURS AND PMR446 programed and working. Actually worked better using Chirp I have another mobile on the way hope it works just as well Inhave my handhelds baobeng uv5rm and uv5r mini...

Hi I recently purchased a 779uv can it be programmed to run both gmrs murs and maybe possibly pmr446? I tried with chirp and anytone software can't get it use murs or pmr446 with chirp bit won't even attempt to program anything but gmrs anybody have this issue nor know what...

Hi all is there a way to program these baofengs a & b separately? I want to program GMRS FRS into the A And MURS and PMR into B using chirp across multiple radios I have the Minis extendes to use gmrs But not sure about the A and B separately option Thank You

Not sure if my post was sent I did the 11 Meter mod and audio mod.. About to. Install rt1 mosfets. Does anyone. Know what W3 W5 & W7 adjustments are for? Thank You

Hi all I did the 11 meter mod audio mod about to put rt1 mosfets in does anyone know when W3 W6 W7 pot adjustments are for?