Recent content by Harley3315

I Guess the question is is it maybe just a misprint about the 3mhz transition frequency? Maybe it's supposed to say 30mhz. Has any actually tried them? I know that I tried the hg1969 and it didn't go well in a 29 with the tip120 mod they usually fail catastrophicly! What about the cb20? In the...

How about instructions to install this in a CBS-500?

Found the other radio, Kraco 2330A. It has some kinda upper channel mod done to it using the Delta Tune and the 2 push buttons. PTBM029AOX

I just think we could make this a performer with a bit of work hope to see what we can come up with soon!

Id be shocked if anyone could find one!

Anyone got a better plan here? swing mod like j36 mod and a better way to bring up modulation cause the way that's listed now sucks with aany power mic at all! or maybe some hifi?

Still crickets from Anytone. bummer

Yes I also scrolled through the pages and pages of that forum as well on the subject it seems it stopped just short of getting lowers to work even downloaded all the attachments and looked them over very carefully.

Yeah, I looked at that first and just checked the master mods to see if it's mentioned the pll01a that is, and it's not at all. Can't for the life of me remember it was some old-timey looking printout someone scanned, if I remember correctly. And No master here Lol thats Nomad 100%

Yeah your wrong cause I've actually done it I just should have made a video or wrote it down. I Originally found the how to in a vintage publication on the net swore it was secret cb but I've looked and looked for it again and cant for the life of me fine it! It told the whole story which pins...

One is the 13-888 Midland still haven't found the second

Which Magnum? I have a 257 Id like to do as well as something better for the Cherokee 500 and 1k far as I know modulation mods for the latter are cut out a transistor q something or other but then a power mic like d104 sounds horrible on them. An npc or j36 type mod for the 500 would be pretty...

Crystal kits I assume care to share instructions??

I actually have 2 one is an early midland board and the second is a kraco if I remember correctly I'll look in the am and post the right models for sure I think they are pretty much the same board and lay out pre 13-882c cause those have the 02A.

Guess I was looking for a bit more simple answer like what pins need cut bridged with a 3.3k and to ground or pin 7 I think it is ? On the 01A