You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
It's been awhile since I've had the radio on the bench but will try my best to provide accurate answers.
The radio was showing no output on the meter on AM with no modulation and sorry but did not check it initially on SSB. There was a damaged trace which I repaired which brought back the AM...
The radio does not have the MOSFETS. Modulation on SSB is about 40%. Since the first post I've removed the mod limiter to get about 30% modulation on AM and the 40% on SSB. I would rather not run the radio without the mod limiter if possible.
Thanks John
I have the above radio (board # EPT069610Z). Radio was at no TX at all but did get the carrier back but I'm only getting about 50% modulation at 4 watt dead key and it's swinging to about 8 watts. VR 18 (low power) has no effect on dead key and if I adjust VR 14 (high power) to over 6 watts I...
Does anyone have any experience calibrating these meters. There are 5 pots inside 4 on the left as you're looking at the front labeled RP4, RP5, RP6, and RP7 from top to bottom and there is one on the right labeled RP1. I can't seem to find the one that affects the SWR meter. Any help would be...
Homer,
For some reason I missed your reply :unsure:. Thanks for the compliment and yes that is what I meant. As of right now haven't been able to work with it any further but will fool around with things and let you know.
John
Doc,
I'm sorry I was not clear. The antenna is showing physically short according to my SWR readings. I know that adding to the radiator would tune the antenna but I'm going to try messing with the tap point on the coil and the ground radial angles. Thanks for the come back. :biggrin:
John
Finally got the antenna up in the air. Had to settle for 32ft. at the feed point but that's alot better than 6ft. where's it's been for the last two weeks. Had to replace the bottom section as it snapped in the first attempt to get it up but was able to fix it and eventually got it all in place...
Thanks Rick. So far the antenna has performed alot better than expected and I'm really excited about getting it up in the air.
Homer, I picked up 40 ft. of 1 1/4 inch EMT and I'm going to try to use it all, will let you know how it goes once I get a full day to work on it and some good...
Well, for the last week or so I've been putting the antenna through it's paces and doing some tweaking and getting all weather-proofed getting ready to get it up on the house in it's final position. Here are the final results:
Radiator length: 23ft.
4 ground radials at 102" each.
SWR...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.