-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
-
A Winner has been selected for the 2025 Radioddity Cyber Monday giveaway! Click Here to see who won!
Recent content by W4ABF
-
W
SWR jumps when power is increased
Yes, I replied to your email, did you not get it? I have decided to keep the MFJ for now as it supports VHF and UHF. I didn't realize the RigExpert didn't, and the model that does is too many $$$- W4ABF
- Post #13
- Forum: General Ham Radio Discussion
-
W
SWR jumps when power is increased
For $25 plus shipping, it's yours. It works as advertised, just looking for an upgrade. My address is good on QRZ, is yours? PP to philliphare1@gmail.com- W4ABF
- Post #10
- Forum: General Ham Radio Discussion
-
W
SWR jumps when power is increased
RigExpert on the way...- W4ABF
- Post #6
- Forum: General Ham Radio Discussion
-
W
SWR jumps when power is increased
Good ideas - both. I only experienced this on 160, so it could be either. Bob Palamor replied quickly to my question and suggested an 80-100-foot counterpoise in addition to the coax. When it warms up a bit, I'll try that. The UNUM is rated for 1500w PEP. It behaves normally at 500w FT8 on 6-80...- W4ABF
- Post #5
- Forum: General Ham Radio Discussion
-
W
SWR jumps when power is increased
Thanks - I have a MFJ but it's headed for the recycle bin. I have a AURSINC NanoVNA SSA-2N V2.2 as well as a RigExpert AA-35 on my Amazon shopping list, deciding between the two. Suggestions?- W4ABF
- Post #4
- Forum: General Ham Radio Discussion
-
W
SWR jumps when power is increased
I recently installed a Palomar 160 EF (173' with the 1500W UNUM). All bands 6-80 are 2.0 SWR or less (untuned/matched) except for 160. It's closer to 6:1 according to my tuner (yet 2.5 per LP-100A). At any rate, the tuner brings it to 1.5. All works fine on all bands (except 160) with 100-500W...- W4ABF
- Thread
- Replies: 14
- Forum: General Ham Radio Discussion
-
W
Yaesu FTDX-10 TX Delay setting
Thanks, but that is QSK delay time - not TX delay. -
W
Yaesu FTDX-10 TX Delay setting
I am able to set the TX delay to 20ms on my Flex 6600M, but nowhere in the menu, on forums, or in questions posed to YAESU, DXE, Flex, 403A have I found this setting for the FTDX-10. This delay is required to operate the Genius TGXL and PGXL. Does it exist - and if so - where? Or, if there is...