Search results

I have two Baofeng UV-5RTP These are the triple power ones 1, 4, 8 watts, I keep it on 4 watts which rally puts out a little over 5 on 144 and just 4 on 440. I also use a Wouxun KG-UV8D. All of these are dual band. The Baofeng are alittle more detailed to hand program as after you save the main...

I sold one of them back in Nov. For $69.00 Yes they do have automatic SSB

These are good for like an amp or something that doesn’t need good voltage regulation as they will drop voltage at high current draw. Don’t use them on SSB radios or you will wouble all over. They are made to run 12 volts in RV’s like lights, AM/FM radio, water pump.

how about a 101B Maybe able to get on of these.

Doesn't look like a BNC it looks more like an RCA

Wire it to the battery maybe the circuit you are using goes to the injector kill circuit. I own a 7.3 too. it funny when your going down the road at 65 and key up the radio

no there pins, just make a little switching board with a transistor and you can switch back between 11 and 10 meters. that's the way we use to do it back in the good old days or just wrap thin wires around the pin and put it in. spring out of pens make good crystal sockets.

yaesu 41.4875 looking for other one may still have them

If they changed the mic plug unless you can get ahold of the seller you will have to play with it as if your 4 pin you have doesn't work its anybody guess how he wired it.

Fancy Name for tone control. When you turn it on it will make your receive more bass. it cuts out the highs.

It no doubt a SB-200 or SB-201 1200 watt input (output between 600 to 750 watts) you can look at the back he may still have the serial number on there. These are very good amps. The major problem with them is they were made back in the early 70's and a lot of the times the caps are dried out and...

Does any body know the frequency range of this meter. And does anybody have a schematic for this unit as you can't check modulation it just can't be set. I'm open to ideas. I'm just trying to get it go for my friend he just needs it for a reference. Thank You in advance.

Well I sure if you only need two you could see if someone else needs two and order a set of matched quads. or keep the other two for back up

here you go

First make sure its receiving on LSB, If it doesn’t then I would look at the crystal and varator circuit for LSB, If some opened up the clarifier (voice lock) they may have used an inductor to give it more slide and it could be lose or bad or the crystal could be bad. Remember 858's has a state...

Any where between 28.300 to 29.700, But you will find most of it between 28.300 to 28.700 on USB

Sounds like a set of finals if you have no output on any mode

I asked him and he said he can check them, No problem. I don't know where about in NJ you are. But I know he works over in Monroe by exit 8A, maybe you two can get together, I believe he is still in TR and hasn't moved yet.

if you are doing what I think you are doing and that is to take the 124 ft and coil it to about 4 ft in lenth. You will have a very nice 80 dummy load, it will work but very little distance,

The real way to check them is if you have transistor checker that does HFE. Even the chink ones can show a high gain and can still be fake. I bought a few of them chick ones and out of 25 of them 4 could be used. But I will tell you this the ones that did work has better gain and matched better...