Search results

You have the right to bear arms under the 2nd amendment and to refuse a search with out a warrant under the fourth amendment. You do not have the right to commit verbal assault and physical battery upon another person who is not a threat to your immediate safety and is abiding the law. This...

Sounds like you have a Cap going bad in the audio amp. as current passes through it it gets hot and expands internally causing a dead short (the buzzing noise) as it cools it contracts making contact again allowing the audio to pass.

I had two of those over the years. Both where high strung and didn't receive worth a Dam. I gave one to a neighbor and a stranger stole the other one + all my gear and the shack. I 'm still laughin at his stupidity he got a real mud duck in a drafty shack with bad plumbing.

Nice set up I wish I had that tower.

I used to use a Shop in Ontartio Ca for my HF radio but since Bill Goode went silent key about 9 yrs ago they went to hell, I feel your pain In my 20 +yrs livin on the raod I have been there a few times. The only palace I would send that radio if it was mine is to http://www.dtbradio.com/ he did...

I can take the heat so flame on..... A D104 IMO is about the worst choice for a Mic especially for use on SSB. I have never understood the appeal & love affair for Power mics on radios. A high quality Dynamic mic with a range from 50- 15,000 hrtz has much better sound & tonal quality with no...

Sounds to my like a low voltage issue. Where are you getting the power for the amp and how is it grounded? What Coax are you using for a jumper from the radio to the amp?

I didn't say they are unreliable but sometimes a mag mount will not make a good enough contact through the paint to allow the antenna to see the counterpoise well enough to get an acceptable SWR. An easy way to see if this is the problem is to run a temporary ground strap from a known ground on...

Mag mounts can be a real Sumbeach I never liked or had much luck with one. The main issues is getting it to see the vehicle to establish a proper counterpoise with out that you will never get the SWR's under control. Because you do not have a mechanical ground the magnet is being hampered by the...

Call the the local cop shop hang up call Report domestic disturbance woman screaming at the PIA'S address PD is required to do a walk through on domestic calls

^^^^this^^^^

Best fix>Build a Slip Seater Box! Or get a pack of mini bungi cords (truckers duct tape) Barjan used to sell a roll of velcro that was about 3 ft long and a 1/2" wide that had fuzz on one side & spikes on the other I have use both with equal success when I had to drive another mans truck before...

The old AS Droopy Drawers was a fantastic antenna I have seen it out preform Moonaker 6's and Stardusters leaving 'em scratch their heads & cursin like a sailor. I live in a steep Valley with a 150 ridge on the east & west sides within 1 mi total. My inverted V at 30 ft out preforns my Imax...

I might be mistaken but IIRC using the VR on the solder sided is one way of doing a Mosfet install on that chassis to adj the gate V

That boy is surenuff proud of his stuff, I wonder how he sleeps at night... 35.00 fer monetary contact switch in a 2.00 box :censored:

A good foot switch can be had at the Singer Sewing machine store IIRC I paid less than 10.00 for mine.

You got it.... well ...almost.... 10 meters is HF

As a Tech class you're limited to 28.300-28.500 for Phone on 10 meters JM2C here but if you're wanting to get into Hf Take the test for General from the git go and get either a good used hf rig or a New Alinco DX-SR8T/E for about the same investment. If you pass the Tech take the General while...

If your working strictly AM with your 148 Direct injection through C174 is the way to go. However if your using the sidebands it wont work because a 148 uses a BFO chip if you try to inject at pin one of the BFO chip you will be transmitting on both upper & lower side band simultaneously. So if...

I l already have in fact I was born here.