Search results

mine came out like this, Material 3/4" emt outside dimensions are a=155.0" b=29.5 " c=7.0" d=20.0" 1" gap at feedpiont graphs are here-> http://www.worldwidedx.com/threads/so-much-for-building-a-moxon-today.174395/#post-496130

I have him as 119 in my rough notes. but notes are really rough

what tool/device do you use to monitor a given frequency range??

yep, tc254 Ken from texas was gabbing with a bozo from NJ and covering up all my UK traffic for like 30 minutes. Most of the UK guys I contacted qsy elsewhere and we can have a 2 minute chat. On occasion other UK stations will hear us and call me when QSO has completed. The brits have a way...

It was tuned about 1.33 meters above ground laying on two wooden closet doors sitting on top of two plastic recycling barrels . When it is erected on the roof, it will be about 10 meters above ground.

Thanks, I'm pretty satisfied. unknown, I don't have a tool to measure that yet, not certain that I want to allocate resources just to look at a number that I wouldn't be able to tune anyway. I must admit it is a bit annoying when listening to UK stations calling CQ and half of Texas walks...

out here NY/NY poppers are jalepenos sliced in half length wise, then filled w/cream cheeze , battered and deep fried. call them what you will, but all are tasty Hot peppers were never big in the German community back in Iowa.

1 jalop 2 pepperoni 3 cheddar cheeze 4 taco mix clean out pepper lay 3/4 pieces of pepperoni inside sprinkle taco mix on cheeze stuff pepper with cheeze heat in over or grille

first tuning pass, getting closer.....

first attempt, not tuned yet, not half bad...

Yes I wanted to but I made it home depot and bought a bunch of parts. Feed point is built, now on too measuring once and cutting 5 times ;-)

I'm beginning to wonder how one can correctly assemble any antenna without an analyzer. Now the question is how to move x left .5MHZ. My inclination that fiddling with the gamma matcher wont move X and that either moving the reflector away or the lengthening the driven element is how to move...

quick test.... 25.5 = 2.0 swr 28.4 = 2.0 swr lowest observed swr 27.632 - 27.712 @ 1.07

I shouldn't have even turned on the radio this morning. Conditions to UK, Germany, and France were great today. West coast started coming in mid afternoon. Spent 6 hours chatting. I'm not turning it on tomorrow!

yes it is! Thanks! I will upon return. measured from coax at transmitter input end. 50' of DX engineering rg-8U. No way I was climbing 15' up a pole. I get sweaty palms just standing on a shallow pitched roof. yes, I can locate those bounds, produce an post those graphs. I spent some...

These are the graphs for the antenna analyzer. Focus for right now is 27.385 comments on how it looks? Thanks

where does one locate the audio frequency range for a given radio?

do you recall the length of slightly?? moxgen gave you dimensions based on 27.385 which yielded meter reading of 26.949 = .525 low. inserting 27.910 in moxgen gives a difference of 2.94" in the A dimension. When you shortened driven, did you widen the feed point and pull the ends closer...