COBRA 29 LTD AND LTD CLASSIC EXPO 100 KIT INFO

[cottentop]

hi I hope I am in the right forum
I need help can you use an EXPO 100 A kit in any cobra 29 tld / classic and if not what would be the difference in the A and A+ and can you make an A kit work ?? thanks Wayne

 

[sonoma]

the A kit has a toggle switch on it and the lower channels are 1 channel low as per most other radios. the A+ kit has a rotary switch and it will go right in place of the delta tune slot. which you do not need. all channels line up as all other radios do with the A+ kit. have not put one in the latest cobra 29 radios so not sure how it works in them. I have an A+ kit I need to install in a few days myself.

 

[cottentop]

thanks so can I put an A kit in an 29 glt and the 29 classic some say the 29 classic should use a n A+ kit thanks

 

[TonyV225]

I have bothe the S+ amd S- kits brandnew in the boxes with instructions here Ide sell or trade. These boards give you uppers (+ board) and lowerrs (- board) I listed them a while back but nobody needed them so I put them away. if interested message me Ill never use these so Ide sell or trade them to someone who can use them.

 

[cottentop]

hi as I understand it that s+ and s - kit would be fore a cobra 25 ltd so dos the 29 and 25 both use the same PLL and vco just my understanding am I wrong

 

[dss56]

I know the post is old but I do sell the Expo 100 A and S kits any combo you want and toggle or 3 position rotary sw to fit in the front fine tune location.
look on facebook dj56cbsales and message me

 

[9C1Driver]

cottentop
Member
Male, from the panhandel of WV
Profile Page Start a Conversation Follow Ignore
Member Since:
Nov 21, 2008
Messages:
67
Likes Received:
2
Trophy Points:
16
cottentop was last seen:
4y 45w ago


Guy has not logged onto the forum for almost 5 years now. He's probably not going to see your post.
If you really want to sell those kits I would post it in the cb sales section of the forum.

 

[skeet]

the A kit has a toggle switch on it and the lower channels are 1 channel low as per most other radios. the A+ kit has a rotary switch and it will go right in place of the delta tune slot. which you do not need. all channels line up as all other radios do with the A+ kit. have not put one in the latest cobra 29 radios so not sure how it works in them. I have an A+ kit I need to install in a few days myself.

 

[skeet]

I have the expo A+ kit for the cobra 29 ltd. It is missing the diode. Can someone tell me what diode I need ? Thank you

 

[Uncle Ronnie 336]

the a and s kit have different crystal freqs.

 

[nomadradio]

what diode I need ?

Best of my recollection that pc board has two crystals, two trimmer caps, a transistor, resistors and disc caps.

Don't remember a diode. The "N" kit had a couple of varactor diodes, one for each crystal, and a green clarifier wire wire not used by the "A" and "+" kits.

73

 

[smoke blower]

I have a cobra 29 ltd classic and I have a expo 100 kit here will this give me 26.535 mhz

 

[smoke blower]

I have a cobra 29 ltd classic and I have a expo 100 kit here will this give me 26.535 mhz

Which is channel 3 lower channel