Recovered the little threaded core and it isn't damaged, but its like it doesn't seem to fit the threads in coil, it just slips on by and falls to the bottom.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
-
The Winners of the three Retevis radios 16 Anniversary giveaway are announced!! Click Here to find out if you won!
Help with Uniden Grant XL
- Thread starter crappykraco
- Start date
take a little section of a thin rubber band and put it vertically on the ferrite slug.
then insert it into the core. should be able to get it to thread in then.
LC
then insert it into the core. should be able to get it to thread in then.
LC
Sometimes I'll rest a small piece of paper or snip of rubber band in the hole before threading the slug back in. It will press it to one side keeping the threaded surfaces in contact. Once you get the carrier back on AM after following the alignment instructions, you can use VR10 to adjust the carrier to 4watts. It will possibly go past 10, but anything over 3 to 5 watts might not fully modulate making you sound quiet or muffled.