hi all,
i am researching the feasibility of building one of these over the summer.
i have a set of plans for building a 2 driving 4 6LF6 tube amp, but obviously these tubes are far too obsolete and expensive to consider using.
yes, EL-509's would work, but im thinking of using a real transmitting tube that will be around for a while to come.
yes, i also know that i could make a single tube amp, but i think ill be happy using the 811a's.
i want to do a 1 driving 4 grounded grid configuration, and i want to know how this will work.
i have an old kenrich 2 driving 5 20LF6 amp that i would like to scrounge as many parts from as i can.
is this possible?
is the plate voltage required for the 811a's too much for the components in the kenrich amp such as the tune and load caps?
the plans i have are basically to build a palomar 350z amp.
so can it be done?
basically, build a 1 driving 4 sweep tube amp but use 811a's?
any insight is appreciated.
LC
i am researching the feasibility of building one of these over the summer.
i have a set of plans for building a 2 driving 4 6LF6 tube amp, but obviously these tubes are far too obsolete and expensive to consider using.
yes, EL-509's would work, but im thinking of using a real transmitting tube that will be around for a while to come.
yes, i also know that i could make a single tube amp, but i think ill be happy using the 811a's.
i want to do a 1 driving 4 grounded grid configuration, and i want to know how this will work.
i have an old kenrich 2 driving 5 20LF6 amp that i would like to scrounge as many parts from as i can.
is this possible?
is the plate voltage required for the 811a's too much for the components in the kenrich amp such as the tune and load caps?
the plans i have are basically to build a palomar 350z amp.
so can it be done?
basically, build a 1 driving 4 sweep tube amp but use 811a's?
any insight is appreciated.
LC