• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
  • Click here to find out how to win free radios from Retevis!

I am looking for the manual for a Redco Digiscan Ufo (not the one that is easy to find, the other one.)

Enterprise312ok

Sr. Member
I Support WorldwideDX.com!
Jun 12, 2022
637
715
103
36
I have had this old Digiscan Ufo laying around for about a year and a am ready to install in my restored 138xlr, but the manual I can find is for an earlier model. My Digiscan has only 2 movable blocks and 9 switches not like the 13 movable blocks pictured in the manual I have been able to find.

Here Is a copy of the one I can find
 

Attachments

  • Redco_Digi-scan_UFO_user.pdf
    1.9 MB · Views: 8

I have had this old Digiscan Ufo laying around for about a year and a am ready to install in my restored 138xlr, but the manual I can find is for an earlier model. My Digiscan has only 2 movable blocks and 9 switches not like the 13 movable blocks pictured in the manual I have been able to find.

Here Is a copy of the one I can find
I believe I have the same unit as you do. I was unable to locate the correct manual either. Someone has it out there, hopefully they see this.
 
  • Like
Reactions: Enterprise312ok
Try Installation #5, Code 1, and Alignment #4. My UFO Elite is the same as the DS-400. A little bit different than yours but I bet your 2 blocks are the same as J1 & J2 in the DS-400.
 

Attachments

  • digalog_ds400_installation.pdf
    6.5 MB · Views: 6
  • digalog_ds400_om_addendum.pdf
    529.9 KB · Views: 2
Last edited:

dxChat
Help Users
  • No one is chatting at the moment.
  • @ Deon:
    Good day, I have an Icom IC910H radio. I want to program a memory with split frequency tone on TX only and NO tone on RX,. Is this possible to do from the face of the radio? I don't have the interface to connect to a computer.
  • @ crappykraco:
    @Deon very unlikely to get a response here. You are better off starting a thread on the topic.
  • dxBot:
    Backwoods40 has left the room.
  • dxBot:
    GlocknSpiel has left the room.