Separate names with a comma.
Discussion in 'CB and Export Equipment and Accessories' started by 357, Jun 11, 2018.
Looks like the 6LF6 version.
More than a couple of 40 year-old (or close) filter caps visible.
Could it be this clean because it never worked right?
Does tend to keep the mileage low.
Nice looking unit.
Please don't tell what you have invested!
It might be a basket case but either way my idea was to "just have it".
Its really a piece of history.
$125 I couldn't pass it up.
Don't know how much cheaper you would ever hope to find one that clean.
The last few of them I have seen didn't look this good.
I figured even if the B+ winding is toast, just to have it and look at it is enough.
It's like a trans am of amps.
I'd buy a mint trans am with no engine all day.
A corner of the lid got bent a bit, no big deal.
1 meter has some rust in it but it cleaned off. I'll spay something like nutrol in it to loosen it up.
I'm happy it got here in 1 piece.
Yo 357: Inquisitive minds want to know if the tubes came with it?
Have a old Palomar Skipper 300 that I have been getting parts for over the years to run two each 4CX250B's with a separate power supply, leaving the front panel totally stock for old time sake. Palomar 300+ !
Dang it 357.I can't in-hear that!
Congrats. A deal is a deal. I probably would have done the same thing.
I tested the HV winding, 400+ vac.
Pin 1-ground 14.5 vac
Looks like 20lf6...
Jay: no tubes but thats ok.
so this one runs the filaments in series and takes 120v AC to power them?
looks a lot like my Kenrich Eagle VIII, except mine is 2 driving 5 20LF6's.
im sure you already know this, but you can use 26LX6's as a sub, but i believe there is a pin to cut off or something. can't remember.
beautiful looking amp. hope you find a good deal on some tubes for it.
This one has a proper filament winding.
Tubes are gonna be tough, I got 1
That should be a fun project! Looks like it was well taken care of and not butchered! Cool.
It is funny you say that! In trumpet world if a trumpet looks beautiful in it's orignal finish and was a popular design and the price is right something is normally wrong with it!