I recently purchased a General Lee and had some modifications done—talkback relay put in, modulation limiter (governor) removed, and had the receive increased. When I placed the radio back in my dump truck, with the power on low and the amp turned on only—no other buttons—I get a constant squeal. This didn’t happen before the radio modifications. The radio works fine without the amp, but with it it squeals on low power. I tried it out on high power, and I don’t receive a squeal. I don’t want to run with the radio on high with the amp on and rush damaging my radio. Any suggestions as to what the issue could be?
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Squealing on transmit—TX Star 500V
- Thread starter Trina
- Start date
" This didn't happen before the radio modifications"
I am a big fan of Not removing AMC controls.
It Invites many problems.
What was done to "increase" the receive ?
You should not need to run the radio on high to drive a 500.
Honestly I would put the limiter back as it was and adjust it properly as a start.
73
Jeff
I am a big fan of Not removing AMC controls.
It Invites many problems.
What was done to "increase" the receive ?
You should not need to run the radio on high to drive a 500.
Honestly I would put the limiter back as it was and adjust it properly as a start.
73
Jeff
Somebody needs to ask.
Do they hear a squeal on your modulation with the talkback turned off?
73
Do they hear a squeal on your modulation with the talkback turned off?
73
- No one is chatting at the moment.
-
-
-
dxBot:63Sprint has left the room.
-
dxBot:kennyjames 0151 has left the room.
-