I know it's not a lot, but it works for me.
2012 Tundra 4X4- Wilson 1000 - Galaxy DX95T
2012 Tundra 4X4- Wilson 1000 - Galaxy DX95T
Attachments
Last edited:
From the looks of the doors it must be the Crew Max model. I have the same truck.....2012 Tundra Crew Max with the 5.7 liter 4X4 in metallic magnetic gray. No gear in it yet but may get a 2m or 2m/70cm radio in there eventually. Mounting an antenna is the issue for me. Can't (won't) use a magmount. No place to run the coax anyway except thru the doors and that has issues. Huge sunroof eats up a lot of groundplane too. Can't use a hard roof mount because of the retractable sunroof.Can't use a glass mount on the rear window as it is a power vertical slider window. Can't use a regular stake-hole mount due to the tonneau cover. It is one damn fine truck but just not radio friendly in my application.
Nice truck. I used to able to mount a TS-440SAT under the dash of a 1985 Ranger. Now I have a 2014 F-150 and not even enough room to mount a 2 meter radio without a remote control head.
CK - Not to derail the thread but Breedlove makes a stake hole mount made to use under camper shells that mounts beautifully under a tonneau cover. I'm using one and it's so flat that the weather seal under my Xtang Trifecta molds right around it.
Nice truck. I used to able to mount a TS-440SAT under the dash of a 1985 Ranger. Now I have a 2014 F-150 and not even enough room to mount a 2 meter radio without a remote control head.
CK - Not to derail the thread but Breedlove makes a stake hole mount made to use under camper shells that mounts beautifully under a tonneau cover. I'm using one and it's so flat that the weather seal under my Xtang Trifecta molds right around it.
I own the Breedlove antenna stake hole mount, but it won't work with the newer camper shells that "curve" over the truck bed. Outstanding mounts though.
It will probably work with me as I have the three section folding tonneau cover from Toyota and it sits flat against the siderails.
Nice truck.
I may have an idea, I used it for my truck with a canopy. i took a coathanger wire and made a contoured form. From that I had 1/8 stainless which I bent the shape. Used 4 screws connecting to a plate in the pocket hole. From there I mounted a ball mount onto the plate. No problems with the canopy at all.