Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Where to find this cable

HomerBB

HomerBB

Sr. Member
I Support WorldwideDX.com!
Jan 4, 2009
4,012
2,809
273
69
Rogers, Ar
I'm wanting a RJ45 to RJ45 repeater controller cable for the QYT KT-8900D pre-made. I don't want to make one. I want to buy one. I make antennas, not rj45 cables. Surecom offers an RJ45 to 3.5mm speaker mic cable, but I want to pair two mobiles, not a mobile to HT for crossband use.
 

I think your right... it should be pin to pin...
But, this confuses me:
"
  • Wire the cable according to the standard crossband repeater pinout: Pin 1 (Data In) to Pin 7 (AF Out), Pin 2 (PTT/COS) to Pin 8 (PTT/COS), and Pin 3 (Mic Ground) to Pin 5 (Mic Ground). Do not connect Pin 1 and Pin 7 directly; they are separate signal paths."

Doesn't look like pin-to-pin.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ Hambones amps:
    Does anyone know if you can replace the 2290 in a galaxy dx 93t twin turbine with a 2sc2879 red dot? If so, what would have to be tuned?
  • @ BayouRadioAmplifier:
    hello
  • @ ShadowDelaware:
    Hambones the entire amp section would have to be retuned, and the rf transformers re wrapped.


      Top Bottom