You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
I would try and isolate the trouble using a dummy load.
Start with it at the radio and add a piece at a time. When your Swr goes up, you have found the culprit.
Yup,
Wifes desk lamp, new led lamps in the bedroom (or is it the dimmer), shack desktop computer too close to the imax, battery charger, furnace blower....
Sounds like you might better stick to all knobs.... and one band to keep the finals intact.
If you didn't need SSB a Stryker 447HPC2 would fit in the hole with room around it for ventilation.
Coax seal.
Or 3m temflex 2155 rubber splicing tape. It reminds me of Coax Seal except it activates when you stretch it as you wrap.
You can see the Temflex on Dx Engineering's site.
Our Home Depot has ( had?) the Temflex also.
I've had a couple of the 40 and 50 footers like the ones sold by channelmaster.
Usually had them loaded pretty heavy, supported at some level and the top section dropped down, not used. This is with a good size TV antenna at the top.
For a wire dipole I use the whole thing.
They can be a bit...
A lot of advice offered in this thread, but no one asked what you want a radio to do....
Part of the reason I ask is there isn't much will stand up to wheeling. About the same as putting a radio in a dump truck as far as vibration? Depending on mods of course.
(I do realize this is actually...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.