Search results

I have a neon sign transformer I might make one with. That and coathangers. The guy I got it from made one.

Don't reply all at once, lol. I'll be there all week. 1200 to about 2000 in MI central time.

Try the Imax first, as high as you can. If you get a beam, remember you need a rotor. Not a TV type, a communications sort and they are not cheap. A beam is not the sort of antenna that likes a mast either. It is better on a tower. One can be found at a house that no longer uses it for free...

Anyone there? I'll be there tomorrow and Friday and Sat. early afternoon to Warren and back. Freq, + or - and pl.

Used Icom 2000/2100 and a 1/4 wave whip for the mirror.

I dunno what you mean by the airframe. I think that coax should not be affected much even if it is in EMT conduit.

Ravels, Bolero.

I have a single coil with a 9" shaft. Going OTR again, last time the stinger fell out (my fault) and what good is a driver without a 10K? The one I have is long, a starting point would be cool.

Joe was gay as hell and Curly Joe was almost as bad. THREE STOOGES SCRAPBOOK Part 1 *RARE* TV Pilot - YouTube

I hate you.:tongue_smilie: Living in paradise AND cool antennas?{Cry_river}

CB's were covered in 2 radios. The linear thing couldn't be covered because no truck like that should have any less than 16 pills. But maybe 5 driving 16 would work.

Look for a mount that holds the whip with a set screw. Cut from the base of the whip to about 13".

12 alts, 11 batteries, 10 miles of wire, 9 running lights, 8 ball shifter knob, 7 noise toys, 6 feet between hots, 5 blue LEDS, 4 gears a shiftin, 3 tuning Birds, 2 radios and a antenna that will beat the trees.

Cut a VHF 1/4 wave whip. Or take a cheap glass CB antenna, cut the plastic coating, unwind the wire, cut the glass to length and run the wire straight up. Tape or shrink wrap and use a cap hiding the excess wire that you can use to tune it Fold or unfold for SWR. I have a 2M antenna that I...

How about a run down on equipment and antennas of the winners? I'd like to know what a winning combination is so I might consider emulating one.:thumbup:

Very good. Pics?

The only time a person died when I worked for them was from a dumb accident. We were painting a substation in an Armco (I think) steel plant in Butler PA. Butler is the only place I have been that has two Main Streets. You can go to the corner of Main and Main. I was running an airless...

Those high lines outside of high pollution areas really seldom need cleaning. I used to do that and we used lime. Simple line marker calcium carbonate. 80 grit. The only places I worked were where the environment had very high airborn particulate pollution. The steel mills here in NW IN and...

You are right. My mistake was thinking that I had to start with SP1 or 1A. Went to SP2 and it went well after that. Can't do the verification thing (I think) because I tend to repair my own stuff. If a motherboard or HD goes bad, I replace it, so MS seems to think this disc is installed on...

Nope. It's a hobby, just one of a few.