You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Good morning
I have a Connex 3400hp that has had some issues, most have been fixed .
the only one that's being a pain is the talk back.
the owner of the radio said the talk back was always on and he sent to a shop to have it checked out.
this shop could not figure it out and installed a...
Good morning
Looking for some one that could help me out real quick with a Connex 4300hp
Need a picture of both sides of the Circuit board
Who ever worked on this thing did some funky stuff, just trying to figure it out
Thanks
Good evening
Looking for a little help on this galaxy
It’s a 33hp2
Right now I have good carrier on all power settings, modulation on high and medium,
No modulation on low
Anyone know where to start looking to correct this
Also have no meter response
Thanks for you help
Kevin
Good afternoon
Looking for a little help with this radio
Its on the bench and its flat topping and pinched off real bad
tried to adjust modulation at TR14,getting absolutely no response there
Everything else adjust just fine
Is there a limiter theat may have been removed or snipped
Not...
Hello
Have a friends 99v2 on the bench, was checking out the Tx tune and was noticing that, not only do I have to get the gate voltages way up to 4v or more,but wasn’t getting any response from vr18
This radio is very dirty on the scope also
If I back off on the gate voltages (like 3.5)
I get...
Hello Folks
Ive been slowly learning the radio repair biz, and I have a question on the Stryker 655 if anyone could help?
I have been trying to adjust the bias setting and can't seem to get any reading through the amp meter
I have been going by the instruction in the service manual, removing...
Good evening
I have just started in the hobby of repair and tuning radios
I have several Stryker I’ve been looking at
One I detuned to factory specs, clean signal on the O- scope and get nothing but good reviews on the air
The other 2 I haven’t messed with, except to check them in the scope...
Hello
Just starting out on repairing radios and was wondering if anyone had any suggestions on what frequency counter I should be looking at purchasing, getting a little confused with the input ratings,
1 Megaohms bs 50ohms
I’m assuming that a counter with an input of let’s say 30Mhz 1 Mohms...
Looking for a little help setting up a test bench for CB and export radio testing .
Need help with the proper way to set up Oscilloscope with an rf sampler (coupler)and also watt meter and freq counter,im assuming these all need some type of coupler in between them.
Planed equipment to be...
So here's my problem
Had an older trucker 2000 on the truck and had no problem getting a 1.03 SWR reading, while adjusting I stripped one of the set screws and attempted to replace the upper mast , that didn't work out so bought a new antenna (trucker 2000).
Now I can't get the SWRs down below...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.