Hi, this is my first post butt I have read a lot of threads and found most everything I need. I am a retired Electronics tech and have test equipment. Scope, counters, sig gen ect.
After years of being off the air, I start to notice some antennas on vehicles around and decided to dust off the old rigs and see who’s on nowadays. Now I want to spark up the galaxy 959. It has the EPT069610Z pcb w/RCI8719-99 and MOSFET final. I did all the common stuff, zeners, q55/54, clarifier, alc, etc. But I have some questions about the Dual ERF2030+ Mosfet final mods. All the mods posted are pull this, jumper that, change the other and add the transistors, leaving a lot of empty holes. The dx2517 using the same board, has dual finals with all the holes populated around the second final, VR10/VR11 and so on. LESSCOMM populates these holes when he does the mod but won’t tell anyone the process, charges ridiculous prices and takes months to complete. What’s up with the mods that they don’t need the additional circuitry? All I need is 45 watts of clean signal to drive my amp.
After years of being off the air, I start to notice some antennas on vehicles around and decided to dust off the old rigs and see who’s on nowadays. Now I want to spark up the galaxy 959. It has the EPT069610Z pcb w/RCI8719-99 and MOSFET final. I did all the common stuff, zeners, q55/54, clarifier, alc, etc. But I have some questions about the Dual ERF2030+ Mosfet final mods. All the mods posted are pull this, jumper that, change the other and add the transistors, leaving a lot of empty holes. The dx2517 using the same board, has dual finals with all the holes populated around the second final, VR10/VR11 and so on. LESSCOMM populates these holes when he does the mod but won’t tell anyone the process, charges ridiculous prices and takes months to complete. What’s up with the mods that they don’t need the additional circuitry? All I need is 45 watts of clean signal to drive my amp.