Luiton LT-310SDR

[Pez]

Yes, but only the 3.3V TTL 3 wire types (RX, TX, GND). Some are 2 wire (multiplexed) and will not work with these radios.

 

[Nmr2d2156]

Thank you very much! I have the original anytone at-5555 - 3 wire programming cable. Not sure if it is 3.3v but I know the pins on the main board socket to connect it are RX TX and GND. Not sure if you are familiar with that one. I guess I could look at the anytone at-5555 mainoard schematic and see if the ic that the programmer is connected to uses a 3.3vdc to the chip. That would tell me if the cable should work? Or is there a simpler way to just measure RX or tx to GND wire for 3.3vdc? Appreciate any feedback

 

[Nmr2d2156]

Ok. I just looked online, it appears the at-5555 use a 5vdc ttl programmer