Hello all. I've pulled a major screw up on my 2995. I was going over the alignment procedure - specifically, I was checking the Driver and Final mA settings and when I went to remove the test lead (aligator clip) from TP7, I accidently shorted TP7 to ground. A small puff of smoke from, or near, Q66 and the radio no longer transmits. All other functions, including receive, seem to be unaffected by the short.
This is the later model 2995dx with board revision EPT695015A. It's an SMT board, so doing major component repair or replacement is beyond my capability.
My question: Can anyone recommend a good shop or Technician who knows their way around inside this radio? Any advice is greatly appreciated.
This is the later model 2995dx with board revision EPT695015A. It's an SMT board, so doing major component repair or replacement is beyond my capability.
My question: Can anyone recommend a good shop or Technician who knows their way around inside this radio? Any advice is greatly appreciated.