I did use another radio that was tuned by a tech looks like it is my generator that is off not the counter.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
-
The Winners of the three Retevis radios 16 Anniversary giveaway are announced!! Click Here to find out if you won!
Signal generator and hp frequency counter
- Thread starter kaos513
- Start date
It won't.
It will help your freq counter.
DO not use grabbers and a bnc/cable to check freq in a radio, unless you want to screw up your alignment.
That's my point.
Last edited:
Use the oscilloscope leads testing your signals. Good scope probes have a switch on the side of the body for X1 or X10 signal levels. The X1 is 1 to 1. The X 10 position has a resistor divider the attenuates the signal level 10 to 1. If you put ten volts in you will only see one volt at the other end.