You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Problem solved...I was about to change the if board when I saw one of the connectors slid almost al the way of a connection. I plugged it back in and bang. There was the problem. Glad it was this simple. Thanks forth suggestions guys...I owe you all one for the help.
Sent from my iPhone using...
Yea the if. Is centered. I'm leaning towards the ssb filter now but I didn't know they could just go bad. The problem is on all bands...10 meter all the way down to the bottom.
Sent from my iPhone using Tapatalk.
45, North Florida
I turned my 820 on tonight and to my surprise the receive sounds garbled up and like your not really on the right frequency. Any ideas on this? This happens on all bands.
Sent from my iPhone using Tapatalk.
45, North Florida
I run an 820 which is very close to the 520 aside from the freq counter my 820 has. I run a 300 ohm shure sm58 mic to a line transformer to convert the signal back up to high impedance which is what all the kenwood hybrids prefer, then to a 4 pin right into the radio. I get good reports with my...
Thinking about trying one of these to run a mobile 2 meter amplifier and just have good power for my bench but was wanting to get some opinions first. Do they put out clean power for instance?
Sent from my iPhone using Tapatalk.
45, North Florida
I think that would be a good match. Enough drive out of the stryker to get down when conditions are rough.
Sent from my iPhone using Tapatalk.
45, North Florida
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.