I decided to finally put together a Moxon for 11 meters. I ran out of time today to tune it up a bit more, but I did get it together and in the air. A few preliminary transmissions confirm it works. I will not be able to confirm the fabled back door until tomorrow, or perhaps later depending on the weather. I used the Moxon Generator to determine the dimensions and went forward with them. The only analyzer readings I got were at 10' off the ground and without any fine tuning.
Parts:
I didn't realize I had not snapped a photo of the top of the finished spreader plate until now. I'll get it done as soon as I can.
In the air, at 10' to check it out, and at 36':
Analyzer reading at 10':
As can be seen, it is a bit low on the frequency at ten feet.
Parts:
I didn't realize I had not snapped a photo of the top of the finished spreader plate until now. I'll get it done as soon as I can.
In the air, at 10' to check it out, and at 36':
Analyzer reading at 10':
As can be seen, it is a bit low on the frequency at ten feet.