Tightening head on Turner Super Sidekick

[Big Kahuna]

Hey everyone, I'm trying to get chrome cap cover off the back to tighten the head on a Turner Super Sidekick - is it the same as the Turner +3 to get at that screw?

I'm owned tons of +3's but never had a super sidekick with the chrome head so wasn't sure if it was the same. Old posts on here say it is but for the life of me with my thinnest blade I can't get underneath it and it's just damaging it at this point.

 

[Dmans]

Try using low heat from a hair dryer or ??? to soften the glue. The last one I did, the glue was brittle so it came off easily. Cleaned and re-glued when done.

Good Luck!

73
David

 

[Big Kahuna]

Cool, yeah I'll try some heat, I've never had one this crazy to get off, trying not to damage it but the chrome seems softer than the ones on the +3 to get under.

UPDATE - Got it. Took some serious prying, actually snapped the razor blade tip. Some tiny damage to the piece side and a scratch but nothing awful. Head tightened!

 

[ClaimJumper]

Hey guys. I realize how old this thread is, but I have an issue. I've been trying for a couple of days to get that Chrome disc out of there, and I basically scratched it all up when it was in pristine condition. What if I drilled a hole in it and stick a hook in there and pull it out? Cuz it don't seem to be coming out any other way. If I drill a hole am I going to hit something in there? When I put it back in I can cover it with a sticker or something.